Z-Wave Product Information

U-Bolt Z-Wave product can be included in the Z-Wave™ network using S0 or S2 Access Control security. It operates on 908.4 MHz, 916 MHz Z-Wave frequency and integrates with 700 series Z-Wave chips.

This product can be included and operated in any Z-Wave network with other Z-Wave certified devices from other manufacturers and/or other applications. All mains operated nodes within the network will act as repeaters regardless of vendor to increase reliability of the network.

Z-Wave™ and Z-Wave Plus are registered trademarks of Sigma Designs and its subsidiaries in the United States and other countries.

Inclusion Method

This process can only be done once the lock is Set up and connected in the U-tec App.

Open the U-tec App and go to Settings, select Z-Wave Control. The App should state that “Your Ultraloq Smart Lock has not been added to a Z-Wave hub yet.

Tap Add to Z-Wave hub,then follow the App instructions to start the inclusion process.

If your lock has been added to a hub already, please follow the App instructions to exclude your lock from the hub first.

Exclusion Method

This process can only be done once the lock is Set up and connected in the U-tec App.

Open U-tec App,go to Lock Settings, select Z-Wave Control, tap Remove my lock from Z-Wave hub, then follow the App instructions to complete the Process.

Factory Reset CAUTION

Resetting a Z-Wave device without notifying the hub may cause performance problems. Use this procedure only when the Z-Wave hub is missing or otherwise inoperable.

If you are using U-tec App as Owner, please click “Delete and Reset” to remove the lock from your U-tec Account, then use a Reset Needle to push the Reset Button (at the bottom of Interior Assembly) for around 3 seconds until you hear one long beep and two short beeps.

If U-Bolt Z-Wave product is working as Standalone Mode without the App, please use a Reset Needle to push the Reset Button (at the bottom of Interior Assembly) for around 3 seconds until you hear one long beep and two short

Supported Command Class

Z-Wave Plus Info Command Class

Security 0 Command Class

Security 2 Command Class

Transport Service Command Class

Supervision Command Class

Door Lock Command Class

User Code Command Class

Association Command Class

Association Group Information

Battery Command Class

Device Reset Locally Command Class

Firmware Update Meta Data Command Class

Indicator Command Class

Manufacturer Specific Command Class

Multi Channel Association Command Class

Version Command Class

Powerlevel Command Class

Association Group Information

U-Bolt Z-Wave product supports the lifeline group.It contains up to 5 nodes and supports the following command classes:

Door lock operation:Triggered upon a change in door lock operation.

User code:Triggered when user code is added ,deleted and modified

Device reset locally:Triggered upon reset

Battery:Triggered upon low battery

Indicator report: Triggered when main controller requires communication from the lock

4 Likes

Ive been wondering about this. Great info.

The Zwave frequency used in the USA (908.4MHz) is used for mobile phone spectrum in Australia. Zwave needs to be 919.8 MHz or 921.4 MHz in Australia to be legal.